EquilibriumClass 11 Chemistry Case Study Questions
11 Questions
Generated by KedovoAI
Case 1 of 11
Case Study7 marks
The Industrial Synthesis of Ammonia
The Haber-Bosch process, developed in the early 20th century, is a cornerstone of modern chemical manufacturing, primarily for producing ammonia () for fertilizers. The process involves the reversible reaction of dinitrogen () and dihydrogen () in a closed system at high temperature and pressure:
This reaction is exothermic and proceeds with a decrease in the number of moles of gas. To maximize the yield of ammonia, the operational conditions are carefully optimized using Le Chatelier's principle. While a low temperature would favor the forward reaction, the rate becomes too slow. Therefore, a compromise temperature of around is used in conjunction with an iron-based catalyst to achieve a satisfactory rate. High pressure (around 200 atm) is applied to shift the equilibrium towards the products. The ammonia produced is continuously liquefied and removed, further driving the reaction forward. This dynamic equilibrium is a classic example of balancing reaction rates and equilibrium position for industrial efficiency.
Questions on this case
1(1 mark)MCQ
What is the correct expression for the equilibrium constant, , for the synthesis of ammonia?
2(1 mark)MCQ
According to Le Chatelier's principle, what is the effect of increasing the pressure on the Haber-Bosch process?
3(1 mark)MCQ
For the ammonia synthesis reaction, what is the relationship between and ?
4(2 marks)
The synthesis of ammonia is an exothermic reaction. Why is a relatively high temperature (around ) used in the industrial process instead of a lower temperature?
5(2 marks)
What is the role of the iron catalyst in the Haber-Bosch process? Does it affect the value of the equilibrium constant, ?
Case Study7 marks
The Fizzy Drink Equilibrium
When you open a bottle of soda, you hear a characteristic 'fizz' as gas bubbles escape rapidly. This phenomenon is a direct consequence of an equilibrium shift. Soda water is created by dissolving carbon dioxide () gas in water under high pressure. In a sealed bottle, a dynamic equilibrium exists between the gaseous in the headspace and the dissolved in the liquid:
This equilibrium is governed by Henry's Law, which states that the mass of a gas dissolved in a given mass of a solvent is proportional to the pressure of the gas above the solvent. When the bottle is sealed, the high pressure of gas forces a large amount of it to dissolve. Upon opening the bottle, the pressure above the liquid drops to atmospheric pressure. This disturbs the equilibrium, causing the dissolved to rapidly come out of the solution, creating the fizz. If left open, the soda eventually turns 'flat' as it reaches a new equilibrium with the much lower partial pressure of in the atmosphere.
Questions on this case
1(1 mark)MCQ
The principle that describes the relationship between the pressure of gas and its solubility in the soda is known as:
2(1 mark)MCQ
What happens to the equilibrium immediately after the soda bottle is opened?
3(1 mark)MCQ
The dissolution of most gases, including , in water is an exothermic process. How would the solubility of be affected if a can of soda is warmed up?
4(2 marks)
Using the concept of reaction quotient (Q), explain why the soda fizzes when opened.
5(2 marks)
Why is it not possible for the soda to reach an equilibrium state in an open glass?
Case Study7 marks
The Body's pH Regulator
The pH of human blood is remarkably constant, maintained within a narrow range of 7.35-7.45. Any significant deviation from this range can lead to serious health issues. This precise control is achieved by buffer solutions present in the blood. A buffer solution is one which resists a change in pH upon the addition of small amounts of an acid or a base.
The primary buffer system in the blood is the carbonic acid-bicarbonate buffer system. It consists of a weak acid, carbonic acid (), and its conjugate base, the bicarbonate ion (). If an acidic substance enters the bloodstream, the bicarbonate ions react with the excess hydrogen ions. If a basic substance enters, the carbonic acid reacts with the hydroxide ions. These reactions prevent large swings in pH. The relevant equilibria are:
The Henderson-Hasselbalch equation, , is used to calculate the pH of a buffer solution.
Questions on this case
1(1 mark)MCQ
Based on the passage, what is the primary function of a buffer solution?
2(1 mark)MCQ
If a small amount of a strong acid (like HCl) is added to a buffer solution made of acetic acid () and sodium acetate (), what will happen?
3(1 mark)MCQ
An acidic buffer is typically prepared by mixing:
4(2 marks)
A buffer solution is prepared by mixing 0.1 M acetic acid () and 0.1 M sodium acetate (). Given that the of acetic acid is 4.76, what is the pH of this buffer solution?
5(2 marks)
Explain why a solution of sodium chloride (NaCl) in water cannot act as a buffer.