OscillationsClass 11 Physics Case Study Questions
10 Questions
Generated by KedovoAI
Case 1 of 10
Case Study7 marks
The Grandfather Clock's Secret
An antique grandfather clock relies on a long pendulum to keep time. The rhythmic swing of the pendulum's bob, a heavy brass disc, governs the movement of the clock's hands. For the clock to be accurate, the pendulum's motion must be periodic with a very stable period. The designer intended for the pendulum to have a period of exactly 2.0 seconds, allowing it to 'tick' once every second (once on the forward swing, once on the backswing). This is known as a 'seconds pendulum'.
However, the clock's owner noticed that it runs slightly slow on hot summer days and slightly fast on cold winter days. An investigation reveals that the pendulum's rod, made of metal, experiences thermal expansion and contraction. The key to the pendulum's timekeeping ability is that for small angles of swing, its motion is an excellent approximation of Simple Harmonic Motion (SHM), where the period is independent of the amplitude.
Questions on this case
1(1 mark)MCQ
The motion of the pendulum is considered Simple Harmonic Motion (SHM) only under a specific condition. What is this condition?
2(1 mark)MCQ
Why does the clock run slow on hot summer days?
3(1 mark)MCQ
The period of a simple pendulum is given by the formula . What would happen to the period if the brass bob were replaced with a wooden bob of the same size but lesser mass?
4(2 marks)
Calculate the required length of the 'seconds pendulum' described in the passage, which has a period of 2.0 s. (Use and )
5(2 marks)
If this grandfather clock were moved to the Moon, where the acceleration due to gravity is about th that of Earth, would it run fast, slow, or at the same rate? Explain your reasoning.
Case Study7 marks
The Car's Suspension System
When a car drives over a pothole, its wheels are suddenly forced upwards. To prevent the car's body from jarring violently, a suspension system is used. This system primarily consists of a large coil spring and a shock absorber (damper) for each wheel. When the wheel hits a bump, the spring compresses, storing potential energy and absorbing the initial shock. The car's body then starts to oscillate up and down on this spring.
Without a shock absorber, these oscillations would continue for a long time, making the ride bouncy and unsafe. The shock absorber is a piston moving through a cylinder of oil, which creates a damping force that opposes the motion. This force dissipates the oscillation energy as heat, causing the car to quickly settle back to a stable position. The motion is a classic example of damped oscillation. The spring constant for a typical car spring is around .
Questions on this case
1(1 mark)MCQ
If a car had only springs and no shock absorbers, what type of motion would the car's body execute after hitting a bump?
2(1 mark)MCQ
What is the primary function of the shock absorber?
3(1 mark)MCQ
The energy dissipated by the shock absorber is converted into which form of energy?
4(2 marks)
A corner of a car with a mass of 300 kg is supported by a spring with a constant . Ignoring damping, calculate the natural period of oscillation for this corner of the car.
5(2 marks)
Explain the difference between the equilibrium position of the spring by itself and the equilibrium position of the car body when it is oscillating on the spring.
Case Study7 marks
The Shadow of the Ferris Wheel
At a funfair, a large Ferris wheel of radius 10 meters rotates at a constant angular speed, completing one full revolution every 40 seconds. On a sunny day, the Ferris wheel casts a shadow on a large vertical wall nearby. An observer focuses on the shadow of a single cabin on the wheel.
As the wheel rotates, the cabin's shadow is seen to move up and down along the wall. The shadow moves fastest as it passes the midpoint of its path and momentarily stops at the highest and lowest points before reversing its direction. This vertical motion of the shadow is a perfect real-world demonstration of the relationship between uniform circular motion and simple harmonic motion. The sun is directly overhead, so we are observing the projection of the circular motion onto a vertical diameter.
Questions on this case
1(1 mark)MCQ
The vertical motion of the shadow on the wall is an example of:
2(1 mark)MCQ
What is the amplitude of the shadow's simple harmonic motion?
3(1 mark)MCQ
At which point is the speed of the shadow at its maximum?
4(2 marks)
Calculate the angular frequency () of the shadow's motion in radians per second.
5(2 marks)
Write the equation for the vertical position of the shadow as a function of time, assuming the cabin starts at the midpoint () at and is moving upwards.