Areas Related To CirclesClass 10 Mathematics Case Study Questions
11 Questions
Generated by KedovoAI
Case 1 of 11
Case Study7 marks
Car Wiper Blades
A car is equipped with two windshield wipers which do not overlap. Each wiper has a blade of a certain length that sweeps through a specific angle to clean the glass. In a particular car model, each wiper blade has a length of cm and sweeps through an angle of . The mechanism is designed such that the two blades move simultaneously, clearing two distinct sectors on the windshield. The car owner wants to understand the total area of the windshield that gets cleaned during each sweep. For all calculations, you can assume the blade pivots from one end and sweeps a clean sector. The manufacturer's manual specifies that for any replacement or area calculations, the value of should be taken as .
Questions on this case
1(1 mark)MCQ
The shape of the area cleaned by a single wiper blade is a:
2(1 mark)
What is the radius of the sector cleaned by one wiper blade?
3(2 marks)
Calculate the area cleaned by a single wiper blade in one sweep.
4(1 mark)MCQ
What is the total area cleaned by both wiper blades at each sweep?
5(2 marks)
Find the length of the outer arc swept by the tip of one wiper blade.
Case Study7 marks
Decorative Table Cover
A designer is creating a round table cover with a radius of cm. The design consists of six equal segments carved out along the circumference of the cover. These designs are to be embroidered with a special thread. The designer needs to calculate the area of these designs to estimate the amount of thread and the cost. The six designs are formed by six corresponding chords of the circle. As shown in the figure, each design is a minor segment of the circle. The cost of making the designs is ₹ per cm². For calculations involving the square root, use and for , use .
Questions on this case
1(1 mark)MCQ
What is the angle subtended by each of the six equal designs at the centre of the table cover?
2(1 mark)
Calculate the area of the sector corresponding to one design.
3(2 marks)
What is the area of the triangle formed by the chord and the two radii for a single design?
4(1 mark)MCQ
The area of a single embroidered design (segment) is approximately:
5(2 marks)
Find the total cost of making all six designs on the table cover.
Case Study7 marks
Lighthouse Sea Warning
A lighthouse stands on a coastline to warn ships of underwater rocks. The lighthouse emits a powerful beam of red light that spreads over a sector of a circle. The specifications indicate that the light is effective up to a distance of km from the lighthouse. The angle of the sector over which the light spreads is . The maritime safety department needs to calculate the total area of the sea over which ships receive this warning. This information is crucial for creating navigational charts and safety protocols for sailors. For this calculation, the department uses the standard approximation of .
Questions on this case
1(1 mark)MCQ
In this scenario, the distance the light spreads ( km) corresponds to what part of the circular sector?
2(2 marks)
Calculate the area of the sea over which the ships are warned.
3(2 marks)
If the angle of the sector were increased to , what would be the new area of the warning zone?
4(1 mark)MCQ
If the effective distance of the light was reduced to km while the angle remains , the new warning area would be:
5(1 mark)
Find the length of the arc of the boundary of the warning zone at the 16.5 km distance.