Geometric TwinsClass 7 Mathematics Case Study Questions

3 Questions
Generated by KedovoAI
Case 1 of 3
Case Study7 marks

Bridge Truss Design

A civil engineer is designing a section of a truss bridge for a small town. For maximum stability, the structure is built using triangular sections. In the design for a key joint, point CC is the midpoint of a horizontal beam AEAE. A vertical beam BCBC supports the structure. The engineer's plan requires that the triangle formed on the left, △ABC\triangle ABC, must be congruent to a triangle on the right, △EDC\triangle EDC, to ensure the load is distributed evenly. Initial measurements from the blueprint are AC=4AC = 4 m and BC=3BC = 3 m. The design specifies that CC is the midpoint of AEAE and that ∠ACB\angle ACB and ∠ECD\angle ECD are equal. The beam BCBC is also specified to be equal in length to the beam CDCD.
Questions on this case
1
Based on the information that C is the midpoint of AE, what is the length of the beam CE?
(1 mark)
2
The engineer is given that AC=CEAC = CE, BC=CDBC = CD, and ∠ACB=∠ECD\angle ACB = \angle ECD. Which congruence criterion can be used to prove that △ABC≅△EDC\triangle ABC \cong \triangle EDC?
(1 mark)MCQ
3
If △ABC≅△EDC\triangle ABC \cong \triangle EDC, and ∠CAB=37∘\angle CAB = 37^\circ, what is the measure of ∠CED\angle CED?
(1 mark)
4
Assuming ∠ACB=90∘\angle ACB = 90^\circ, what is the length of the diagonal beam AB?
(2 marks)MCQ
5
If △ABC≅△EDC\triangle ABC \cong \triangle EDC and ∠ACB=90∘\angle ACB = 90^\circ, what is the total length of the steel beams required to construct the two triangles (AB, BC, CA, ED, DC, CE)?
(2 marks)